
A customer brought this antique revolver, made around 1850s, with an interesting problem – the hammer only goes on half-cock and the cylinder is not rotating. These revolvers are somewhat rare, they were made for a relatively short period of time by the Massachusetts Arms Company. They had to stop production after the patent infringement lawsuit from Samuel Colt, so there’s very little information about these, and of course, there are no drawings and no spare parts available.
I found this video on YouTube, yes, it’s about the rifle, but the mechanism looks very similar, if not the same. So I went ahead and disassembled the gun.




The issue was with the timing. As the hammer is cocked, it pulls the cylinder stop plunger back so that the cylinder can rotate. At the same time it starts rotating the gear which should index the next chamber under the hammer. I found that the gear under the hammer had a lot of extra play due to a worn out pin, and by the time the gear starts rotating, the cylinder stop plunger is back and blocks the cylinder. Long story short, I machined a slightly larger pin and the problem was solved.