Give A Man A 3D Printer…
… and you feed his Dillon 650! For the past few weeks I was on a quest to make my new bullet collator work with T&B .32 60gr lead SWC bullets. These bullets are tiny so obviously neither .45 nor 9mm setup would work. So I went down the rabbit hole and followed the advise […]
Gospod Bulletfeeder (Slovenian Mr. Bulletfeeder)
I found this bullet feeder device on eBay, shipped directly from Slovenia and the price was less than a half of the original Mr. Bulletfeeder. It works quite well with Brazos coated 200gr bullets, I just loaded about 300 rounds and only one bullet was upside down. Most parts are 3d-printed, but still pretty decent […]