Low Voltage Rock’n’Roll
A customer needed a scope mount for his Bullseye gun. It’s not a particularly difficult part to make, I’ve done it before many times but I always just spray painted the parts with Cerakote or even a regular Rust-Oleum matte black paint. This time, however, I decided to go big or go home and instead […]
I Built Me A Gun And My Gun Pleased Me
This project started as, well, a huge slab of a nice fiddleback maple. It spent several Arizona summers in my garage and got bone dry, and finally I decided it’s time to make something out of it. Hmm, what should I make? Tough choice… After the stock was initially profiled and inletted, the hard work […]
TargetPI – Part I
Warning – this post is full of geek technical terms, abbreviations and computer commands which, if read backwards, can open the gates of hell! Proceed at your own risk! My brand new RaspberryPI is here! What a cute little computer it is! I’m very impressed! And excited 🙂 I ordered a model 4 with 8Gb […]
Electronic Airgun Target – Intro
One of the most enjoyable experiences of Camp Perry for me is shooting the air pistol matches at the Gary Anderson CMP Competition Center. It’s a state-of-the-art facility, equipped with not only the air conditioning, showers and free wifi (super important!), but also with the electronic targets. Yeah, I know, we are all old school […]
Give A Man A 3D Printer…
… and you feed his Dillon 650! For the past few weeks I was on a quest to make my new bullet collator work with T&B .32 60gr lead SWC bullets. These bullets are tiny so obviously neither .45 nor 9mm setup would work. So I went down the rabbit hole and followed the advise […]